Results 1 to 2 of 2

Thread: What can you expect from adding a Cam? LOOK HERE

  1. #1
    Moderator 13secv6's Avatar
    Join Date
    Mar 2005
    Location
    Poquoson, VA
    Posts
    2,653

    What can you expect from adding a Cam? LOOK HERE

    I have continued the assistance to everyone by gathering a list of the board members who have installed aftermarket cams. Supporting mods are basically just general major mods that are done. This is just a reference, every car is different so dont think that if you have the same cam as someone else that your car will produce the same power, or run the same time. Tuning and other smaller mods may put you above or below what is listed here, and as far as track times are concerned, the most beneficial mod is the "Driver-Mod"



    TurboV6Camaro
    Cam Specs: 224/215 .57/.567 116 110 (1.7 rockers)
    Supporting Mods: FFF T-70 Turbo Kit, PnP heads and intakes, Custom Tuning, Forged Pistons/Rods,
    Transmission/Gears: Built 4L60E w/4600 converter, 3.42's
    Times: 11.23 / [email protected]
    Dyno: N/A

    Pector55
    Cam Specs: ZZP GT2 216/216 .507/.507 111
    Supporting Mods: DIY PnP & milled heads 1.86"/1.60", L67 TB, L26 UIM, PnP & milled LIM, .045" MLS gaskets, 7.00" rods
    Transmission/Gears: FWD Automatic w/ 4000 Stall, 3.69's
    Times: 13.987 @ 97
    Dyno: none yet

    WickEdSix98
    Cam Specs: Abbott Racing Custom, 230/240
    Supporting Mods: Abbott Stage 3 heads, Ported Intakes, RK Sport Lid, custom CAI, Custom Long-tubes
    Transmission/Gears: A-4, 4000TCI, 4.56/spool, 12 bolt
    Times: [email protected]
    Dyno: ?

    FloydSummerof68
    Cam Specs: Abbott N/A 210/220 .512/.512 112
    Supporting Mods: Whisper Lid, CAI, Pacesetter Headers, Highflow Cat, Borla Exhaust, 100 rwhp wet shot
    Transmission/Gears: 4L60E Automatic, 3500 converter, 4.10's
    Times: 13.53 @ 100.2 n/a & 12.26 @ 109.3 100 shot (tranny wouldnt shift to 3rd)
    Dyno: Not Available

    NotAV8
    Cam Specs: Custom 221/223 .541/.525 113
    Supporting Mods: Hand-Ported Heads, Ported Intakes, Whisper Lid, FTRA, Pacesetter Headers, No Cat, TSP Rumbler
    Transmission/Gears: 4L60E Automatic 4000 Stall Converter, 3.73's
    Times: Not Available
    Dyno: 239hp/240tq

    13secV6
    Cam Specs: CompCams 210/220 .512/.512 115
    Supporting Mods: Stock Heads, No tuning, Whisper Lid, Highflow Cat, 3" Magnaflow Cat-Back 100hp Wet Nitrous(removed)
    Transmission/Gears: 4L60E Automatic Stock Stall Converter, 3.42's
    Times: [email protected] N/A [email protected] N20
    Dyno: 212hp/221tq

    RallyRed98
    Cam Specs: Custom 218/218 .528/.528 112
    Supporting Mods: Stock Heads, No tuning, Whisper Lid, Highflow Cat, Shorty 3" Dumped Bullet muffler
    Transmission/Gears: T-5 Manual, 3.73's
    Times: [email protected]
    Dyno: Not Available

    Malice
    Cam Specs: CompCams 200/206 .498/.480 112
    Supporting Mods: Stock Heads, Minimal Tuning, 3" Downpipe, SLP Loudmouth,T04 Turbo(7psi) 75hp wet N20
    Transmission/Gears: T-5 Manual, 3.23's
    Times: [email protected]
    Dyno: 188hp/231tq N/A 448hp/471tq Turbo/N20

    Jordan
    Cam Specs: CompCams 216/216 .507/.507 112
    Supporting Mods: Abbott Stage 3 Heads, TSP Tune, headers, Whisper lid, True Duals
    Transmission/Gears: 4L60E Automatic, TCI 3800 Stall, 3.73's
    Times: [email protected]
    Dyno: 223hp/218tq

    Seppo
    Cam Specs: ZZP GT1: 210/210 .507/.507 113
    Supporting mods: Stock Heads, Hand Ported Intakes, Tuning, Pacesetter Headers, Whisper Lid, FTRA, No cat, Z28 Muffler w/cutout
    Times: [email protected]
    Dyno: 239hp/240tq(w/o belt)

    Usd2Sing/DaniCammed8 (same car, Father/Daugher team)
    Cam Specs: Supersix Stage 3 214/220 .526/.526 112
    Supporting Mods: SSM stage 3 heads, Ported Intakes, Tuning, Pacesetter's, Modified stock lid, HiFlow Cat, Magnaflow 3" Cat-Back, 50Hp wet N20
    Transmission/Gears: 4L60E Automatic w/ Stock Stall, 3.42's
    Times: [email protected] 1/8mile (spinning)
    Dyno: 271hp/301tq 50 shot

    This list will hopefully grow in the next few weeks, so keep checking back if you havent seen a cam you are interested in... It just might show up.
    Last edited by TurboV6Camaro; 04-15-2009 at 01:23 AM.

    Drew--F-Body General Tech Moderator



  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Location
    Advertising world
    Posts
    Many

  3. #2
    Moderator 13secv6's Avatar
    Join Date
    Mar 2005
    Location
    Poquoson, VA
    Posts
    2,653
    Please dont respond in this thread, if you have questions or comments about a cam, PM the appropriate person associated with the cam. If I have made a mistake, typo, or whatever, PM me and I will fix it ASAP.

    If you aren't on this list and would like to be, PM me, and give me the information that you have about your car. Also, first check in the "Cam Spec Listing" see if its listed, if not, let me know and I can add it there too!

    Thanks

    Drew--F-Body General Tech Moderator



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •