Results 1 to 1 of 1

Thread: L36 into RHD Toyota stout

  1. #1

    L36 into RHD Toyota stout

    Gday all, hope your well. Putting a L36 3.8L into a '78 Toyota Stout, and have a few questions.
    The motor's an ecotech out of a '03 Holden VY Commodore and has a cupla things that need changing.
    1. It has a front sump pan that sits outfront, where the Stout sway bar is. Is there a standard pan, pressed steel preferably, that sits underneath the motor?
    2. The right hand exhaust manifold has the steering column running between it and the block, and therefore sits out too wide to clear the column in the Stout. Does the LHD righthand manifold sit closer in, like our left hand manifold does, which is near vertical?
    Is there a belt kit, or something, that deletes the power steering pump and air conditioning condenser? Will removing these upset the standard Commy computer?
    3. Is there a kit, or a way, for deleting the heater inlet and outlet castings?
    4. Is there an aftermarket wiring loom, apart from the "V6 Conversions" 1, that will plug/splice into the Stout loom?
    Cheers in advance, RocketScreenshot_20200320-174518_Gallery.jpg
    Attached Images Attached Images
    Last edited by L36 3.8L Stout; 03-20-2020 at 02:50 AM.

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •