Results 1 to 2 of 2

Thread: 105# springs with stock chain?

  1. #1
    Light Throttle
    Join Date
    Dec 2012
    Location
    Richmond VA
    Posts
    177

    105# springs with stock chain?

    I think i remember reading somewhere that this was a bad idea. During the rebuild of the new engine i had to use the heads off my old engine ( nasty deposits in the runners). At the time i forgot i had 105# springs installed for my XP cam. The new engine has a stock cam, but is using the 105s at the moment. Is it safe to drive it this way? or do i need to park it until i can get the time to do the spring swap? If i do drive what am i looking at premature chain and tensioner wear or full on chain snap and bent valves

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Location
    Advertising world
    Posts
    Many

  3. #2
    Light Throttle
    Join Date
    Dec 2012
    Location
    Richmond VA
    Posts
    177
    Contacted ZZP, and was told that i should be okay until i can get my Roll master intalled. The time frame i gave was about two months. So its my understanding that it is safe to run a stock chain with 105# springs at least short term. (This is just an FYI)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •