Results 1 to 12 of 12

Thread: Thought id introduce myself

  1. #1

    Cool Thought id introduce myself

    So i have been a member for awhile but i never really posted because i knew you never had an L-Body section, so i stayed to the beretta forums, but i do see you have a 60* section so i thought i would become active..

    This is my baby, ive been told there are only 3 in the world that are supercharged, mine being one of them..

    Cowl hood waiting for paintt

    My 10 gauges to monitor my girl

    All cleaned up :Yahoo!:

    Mod list..

    -Vortech VG-9 S/C
    -Vortech Bypass Valve
    -8psi Billet Aluminum Pulley
    -Comptech Aftercooler
    -CXRacing Heat Exchanger
    -Walbro 255 Fuel Pump
    -42.5lb Lucas Injectors
    -SS Braided Oil Feed + Oil Return
    -Full synthetic Oil Swap
    -GlowShift Tinted Gauges & Pod
    -3400 Block
    -3500 Ported and Polished Upper Intake
    -3500 Ported and Polished Lower Intake
    -3500 Ported and Polished Heads
    -Comp 26986 Valve Springs
    -Felpro SD Headgaskets
    -LX5 65mm Throttle Body
    -Motor Oil Cooler
    -True Spectre Cold Air Intake
    -2 Bar MAP
    -180* T-Stat
    -Equal Length 1 5/8" Primary V6 Headers
    -FULL 2.5" Exhaust
    -High Flow Cat
    -Magnaflow XLTurbo Dual Tip Stainless Muffler
    -8.2mm Taylor ThunderVolt Wires
    -6061 Aluminum Overdrive Alternator Pulley
    -4 Awg BIG 3 Rewire
    -Battery Relocation To Trunk
    -NGK Iridium Plugs
    -EGR Delete
    -ABS Delete
    -A/C Delete


    -ZZP Aluminum Transmission Pan
    -Hayden Stacked Plate Cooler
    -Full Synthetic Fluid
    -Raybestos Stage 1 Red Clutches
    -TransGo Shift Kit
    -Shimmed Accumulators
    -Hardened/Anodized Sannox Valves
    -Hardened Sannox Output Shaft
    -Hardened Reverse Shell
    -Dual Stripe Modulator


    -Front Strut Tower Brace
    -Rear Shock Tower Brace
    -Front 28mm Anti-Sway Bar
    -Rear 22mm Z51 Anti-Sway Bar
    -Poly Filled Trans Mount
    -Poly Engine Mount Insert
    -Poly 28mm Front Sway Bar Bushings
    -Poly 22mm Rear Sway Bar Bushings
    -Poly Sway Bar End Links
    -Poly Ball-Joint & Tie-Rod Dust Boots
    -Billet 7075 Aluminum DogBone & Poly Bushings
    -Moog Tie-Rods
    -4 Wheel Disk Brakes
    -4 Wheel Stainless Steel Brake Lines
    -Centric Drilled/Slotted Rotors In Front
    -Centric Performance Rotors In Back
    -Centric Posi-Quiet Ceramic Pads
    -KYB GR-2 Struts In Front
    -KYB Gas-A-Just In Rear
    -Intrax 2" Lowering Springs


    -17" Motegi DP-10 Rims with 225/45/17 Michelin Primacy
    -SS Badges
    -SS Valve Stem Caps
    -Audiovox Persuit Remote Starter/Alarm System
    -Stubby Antenna
    -3 Piece CMC Wing
    -BMW E-36 Headlights
    -HID 6000k Xenon Bulbs
    -Clear Turns
    -Redline Racing Hood Lifts
    -Tinted Tails & Side Markers
    -Navigator Fogs
    -Custom Kick Panels & Rear Deck
    -Grant GT Steering Wheel
    -Billet Aluminum Hurst Shift Handle
    -Billet Aluminum E-Brake Handle
    -Billet MRZ Strut Caps
    -Custom Billet Fluid Caps
    -Stainless Gauge Bezel
    -7 Color Changing Indiglo Hvac
    -Blue Neon Front
    -Racing Pedals
    -Custom Painted Interior: Black/Silver
    -Custom Painted Exterior: Stealth Gray Metallic/Black Stripes
    -USBody 2" Cowl Induction Hood


    -Alpine 9886 CD Player
    -Alpine Type-R 6"x9" Rear
    -Alpine Type-S 6.5" Front
    -Alpine KTP-445 Amp

  2. # ADS
    Circuit advertisement
    Join Date

  3. #2 Admin epic's Avatar
    Join Date
    Nov 2004
    Roselle, Illinois
    ... so it's stock?

    Welcome to the site!
    Matt / Owner
    Current Cars: 07 6.0L C6, 14 BMW M235i
    Previous Cars: 08 BMW 335xi, 02 5.7L Firehawk, 06 6.0L GTO, 99 3.8L GTP, 96 3.8L Firebird

  4. #3
    Full Throttle Extreme! xxBatmobilexx's Avatar
    Join Date
    Aug 2011
    Houston, TX
    How were you not an active member?! That's an impressive build!
    2005 Acura RSX - Stock
    2000 Firebird - Borla Pro XS 2.5in Catback, Magnaflow High Flow Cat , Whisper Lid, 3:42 Tuned by PCMforLess. Sold.

  5. #4
    Yeah it's basically stock
    I've just been basically active on my Lbody forum.. And I just recently supercharge this in the fall and had to modify the kit because it was made for a Grand Am..

  6. #5
    dont ask
    Join Date
    Jul 2005
    Highland, Ca
    Good mod list

    What are you using for tuning?

  7. #6
    DHP, i put in a 98' ecu and did a OBD2 swap.. A man named Jon from tunes it for me, i log and send it and he revises than i reflash with his revision.. We did a full VE tune and were into the MAF tune when i had to stop for the winter.. I am currently in the second MAF revision and have less than .5 degree of KR at WOT on 89 octane gas
    Last edited by Slinky; 01-18-2013 at 03:17 PM.

  8. #7
    Half Throttle v6pctech's Avatar
    Join Date
    Aug 2011
    Lafayette, LA
    That's a very cool setup there. Welcome.
    Daily Driver
    : 2004 GMC Sierra Vortec V8 Trim, Red. (Eats lots of rice.)
    Sold: 1996 Firebird 3.8L Trim, Red. (R.I.P.
    - 1996-2013)

  9. #8
    Was fed after midnight Rising_Phoenix's Avatar
    Join Date
    Mar 2005
    Emporia, KS
    Thanks for speaking up. I'm sure you have surprised more than one person with that car.
    Bryce | non timebo mala

    Looks like I picked the wrong day to quit drinking.

  10. #9
    Full Throttle Extreme! hevymetalg's Avatar
    Join Date
    Apr 2008
    honeybrook PA.

    Thought id introduce myself


    Sent from an iPhone...sorry
    98 v6 camaro y87, k&N filter, SLP CAI, ngk iridium plugs, taylor 10.2mm blue wires, corvette servo, transgo hd-2 shift kit, lsd posi 3:23 gay rear!!!!,moog rear lca bushings, moog front upper and lower control arm bushings, moog upper and lower ball joints, new bigger 32mm front sway bar and 19mm rear bar with poly bushings, new poly torque arm bushing, new aluminum lower intake gasket from zzp, pacesetters headers

  11. #10
    4000+ HP, it pulls. MusicMan's Avatar
    Join Date
    Jun 2008

    1996 Camaro, in progress: mild 5.3, TH400, T6 S475, 8.50 chassis cert...
    1993 K1500 W/T
    1985 Yamaha FJ1100
    1979 Suzuki GS550E (cafe racer)

  12. #11
    awesome car! and welcome! dont be suprised if your elected ROTM with that baby
    2000 saturn L200....RETIRED after 300,xxx miles of loyal service
    1993 camaro z28....sold to move home
    2005 grand prix....totaled
    1997 camaro v6 a4 convertable....being fixed and painted then heading for retirement
    2005 Bonneville GXP...the lead sled
    2000 camaro SS...LS1 stock block, LS 243 heads, 2004 LS6 cam, FAST 92mm intake and TB, hooker headers and catted y pipe, Borla 3 inch cat back with cutout....she hasnt seen a set of tail lights yet!!!!

  13. #12
    Thanks everyone! I've been working on it for years In my front yard, my dad never got around to putting a roof on the garage or even a floor ha ha

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts