Search:

Type: Posts; User: 1996Camaro




Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    110

    6290SS hood off, stock hood goes on tomorrow with...

    6290SS hood off, stock hood goes on tomorrow with help from my neighbor.
  2. Replies
    5
    Views
    110

    https://youtu.be/JV1v8OkvrDo heres a short...

    https://youtu.be/JV1v8OkvrDo

    heres a short video, open 3” down pipe, ST2 cam, alot of other engine mods.
  3. Replies
    5
    Views
    110

    Going to get a video of it running tomorrow....

    Going to get a video of it running tomorrow. Found a stock hood but can’t get it for a week.
  4. Replies
    5
    Views
    110

    6287

    6287
  5. Replies
    5
    Views
    110

    Got it done, only bad thing is my SS hood is...

    Got it done, only bad thing is my SS hood is hitting the compressor side of the turbo, going to try a stock hood and if that doesnÂ’t fit do a cutout for it. Install was 8 hours. Trying to figure out...
  6. Replies
    16
    Views
    2,928

    You can use a 97’ Pcm direct swap. Firebirdv6.com...

    You can use a 97’ Pcm direct swap. Firebirdv6.com has pinouts for the pcms. I doubt you are using a 2000 pcm in your 1996 3.8 since their not compatible.
  7. Replies
    5
    Views
    110

    Finally getting the turbo turbo on

    Finally getting the turbo kit on next weekend, eBay turbo headers, Garrett GT35R T4, .63ar turbo. Will post pics.
  8. I would do the bigger injectors since your...

    I would do the bigger injectors since your turboed and need them anyways before pulling the heads.
  9. What kind of problems do you have when you switch...

    What kind of problems do you have when you switch pcms?
  10. Just use Hptuners respository, a lot of stock 97’...

    Just use Hptuners respository, a lot of stock 97’ files. That’s what I use, I went from a M5 to A4 in 2007. Alot of info on Hptuners too.
  11. Yeah the tr6 comes pre-gapped .035 their good, I...

    Yeah the tr6 comes pre-gapped .035 their good, I got my injectors from Intense Racing 65lbers, think they were like $250. Might want to try them. Remember their around 60lbs on our fuel system, so...
  12. Also what spark plugs you using and what gap?

    Also what spark plugs you using and what gap?
  13. Since you need bigger injectors anyway , might...

    Since you need bigger injectors anyway , might wanna replace them with bigger injectors. See if that helps. Since you’ve added the turbo depending on how much boost your going to run I would get...
  14. Is it a po300 code or certain cylinder? What...

    Is it a po300 code or certain cylinder? What injectors do you have? What’s your fuel pump? No vacuum leaks?
  15. Replies
    3
    Views
    1,426

    This site is dead, might as well post on...

    This site is dead, might as well post on Camarov6.com.
  16. Replies
    16
    Views
    2,928

    Thanks, the battery if nothing gets in the way...

    Thanks, the battery if nothing gets in the way I’m leaving. For the A/C delete I’m going a different direction from v6buick on Camarov6.com. Should be doing it this next week.
  17. Replies
    16
    Views
    2,928

    Did you have to move the battery to the rear?...

    Did you have to move the battery to the rear? Also your belt route which way did you do it? I’m going to take my A/C out soon and plan on reroute the belt. Thanks
  18. Replies
    16
    Views
    2,928

    Looking good.

    Looking good.
  19. Replies
    16
    Views
    2,928

    There’s guys that have finished their builds on...

    There’s guys that have finished their builds on Camarov6.com, mine will hopefully be finished this year.
  20. Replies
    16
    Views
    2,928

    You’ll need a 97’ pcm , direct swap, just make...

    You’ll need a 97’ pcm , direct swap, just make sure you get the right trans. I would go with Hptuners and tune yourself.
  21. Replies
    16
    Views
    2,928

    You’ll want it above the sensor, I ran a -10an...

    You’ll want it above the sensor, I ran a -10an line.
  22. Replies
    16
    Views
    2,928

    You’ll have more room on the oil pan, for the...

    You’ll have more room on the oil pan, for the return line.
  23. Replies
    1
    Views
    1,817

    Just use a 97’ pcm and get Hptuners. Some...

    Just use a 97’ pcm and get Hptuners. Some companies only charge $100 to flash the pcm if you don’t want to spend the money for Hptuners. Just need tire height and gear ratio.
  24. Replies
    2
    Views
    4,887

    Tough one maybe in one of the pulleys, mine ticks...

    Tough one maybe in one of the pulleys, mine ticks but between the Comp OER lifters and bigger injectors it ticks also. Does yours get louder when reving it?
  25. 1996 to 1997 pcm is a direct swap, just make sure...

    1996 to 1997 pcm is a direct swap, just make sure you get a 1997 pcm with your manual or automatic and gear ratio. Reason you need to do this is because you can tune the 1997 pcm with Hptuners....
Results 1 to 25 of 149
Page 1 of 6 1 2 3 4