Page 8 of 185 FirstFirst 12345678910111213141516171858108 ... LastLast
Threads 141 to 160 of 3685

Forum: L36 & L26 Engine Tech

Series II & Series III Factory NA 3.8L Motors


  1.   Sticky Threads  

  2. Sticky Thread Sticky: 3800 Series II Cam List

    This list covers every camshaft available for the GM 3800 Series II Engine. They are listed in increasing size starting with the STOCK cam. All...

    13secv6
    3 Pages
    1 2 3
    • Replies: 33
    • Views: 112,285
    06-29-2021 03:38 AM Go to last post
  3. Sticky Thread Sticky: L36/L26 FAQ's

    This has been a much delayed project that I unfortunately haven't had the time to focus on. Moving forward I will keep this thread open for everyone...

    • Replies: 10
    • Views: 16,176
    01-11-2015 10:18 PM Go to last post
  4. Sticky Thread Sticky: Spreadsheet for cam related info

    http://users3.ev1.net/~black_ops/cams/VE%20calculator.xls Sheet 1 - compare two cams (forum post) this was an attempt to put _ in there to keep...

    Dom
    • Replies: 3
    • Views: 14,885
    09-11-2009 07:07 AM Go to last post
  5. Sticky Thread Sticky: got a misfire? read all about it here!

    THE SYMPTOMS: poor idle, part throttle stumble, full throttle stumble, popping noises, solid illumniated "service engine soon" light, flashing...

    • Replies: 2
    • Views: 27,071
    08-16-2007 08:33 PM Go to last post
  6. Sticky Thread Sticky: FAQ: Camshafts and your car

    I have noticed a few more cam related questions popping up on the forums and figured i would throw this up here as a bit of information before you...

    • Replies: 3
    • Views: 18,979
    06-27-2006 12:11 PM Go to last post
  7. Sticky Thread Sticky: What can you expect from adding a Cam? LOOK HERE

    I have continued the assistance to everyone by gathering a list of the board members who have installed aftermarket cams. Supporting mods are...

    • Replies: 1
    • Views: 25,985
    11-17-2005 12:07 AM Go to last post
  8.   Normal Threads  

  1. Blown head gasket or not? Odd symptom

    I picked up an 01 camaro 3.8 5-speed. The guy said his mechanic buddy said it was a blown head gasket. It fires up every time, but it won't go faster...

    • Replies: 11
    • Views: 2,832
    09-01-2014 03:20 PM Go to last post
  2. Stumble shake and misfire under load.

    Long story short my car was working good but now it stumbles past 1/4 throttle in any gear, at any rpm. If I push the pedal down it shakes and...

    • Replies: 7
    • Views: 2,361
    08-29-2014 09:16 PM Go to last post
  3. 3800 MLS head gaskets

    Do they exist? I have $250 to replace my head gaskets (read all gaskets from the heads up) do what's everyone's recommendations? THINK BULLETPROOF!

    • Replies: 9
    • Views: 2,990
    08-28-2014 06:41 AM Go to last post
  4. Motor swap 3.8

    Hello, I have a 2000 firebird w/ 3.8 series 2 motor. The motor needs to be replaced, I am wondering if I can use a fwd series 2 or series 3 motor and...

    • Replies: 3
    • Views: 1,730
    08-17-2014 03:20 PM Go to last post
  5. Car Battery Frying?

    This may seem like a very broad question but I own a 2000 firebird that has been sitting for a couple years in the garage( every time I pull it out...

    • Replies: 5
    • Views: 1,767
    08-10-2014 02:39 PM Go to last post
  6. aftermarket cam with rocker arms

    so I emailed ZZPerformance asking why aftermarket rocker arms for the 3800 say they can't be used with an aftermarket cam and after getting sassed...

    • Replies: 4
    • Views: 1,626
    08-02-2014 04:30 PM Go to last post
  7. stock 1/4 mile times

    I just want to clear something up. I have read all over online that a v6 camaro or firebird will run high 15s. I own a 2000 firebird with the y87...

    • Replies: 2
    • Views: 1,576
    07-31-2014 07:02 PM Go to last post
  8. Doing True duals need help on a budget

    Im looking for someone who has experience with this setup. I have listened to every 3800 firebird/camaro with true duals that i could find on you...

    • Replies: 4
    • Views: 1,917
    07-17-2014 11:54 PM Go to last post
  9. 96 Firebird 3.8 Cylinder 6 misfire

    Replaced plugs and wires myself. (Im a certified mechanic I know the job was done correctly) cam sensor was cracked. Replaced that. When I pulled the...

    • Replies: 0
    • Views: 1,265
    06-22-2014 07:51 PM Go to last post
  10. Lim

    So I'm suspecting my lower intake is warped has anyone ever had this issue

    • Replies: 0
    • Views: 1,239
    06-21-2014 09:49 AM Go to last post
  11. Unhappy Turn Signal Socket Or Turn Signal Switch???

    How would I determine if I've got a bad driver's side turn signal socket or a bad signal switch? (02' Firebird) My left turn signal won't blink...

    • Replies: 5
    • Views: 2,060
    06-20-2014 06:23 AM Go to last post
  12. Oil Pressure

    Having a big problem with my 1997 Firebird 3.8L v6. It has new plugs, wires, coils, fuel pump, oil pressure sensor and tons of other parts. I go...

    • Replies: 6
    • Views: 2,279
    06-10-2014 10:16 AM Go to last post
  13. PCV cover bolts

    I lost both of my cover bolts. Anyone knows the part number for them or bolts that in the same size and Class 9.8? Thanks,

    • Replies: 5
    • Views: 1,723
    06-06-2014 10:17 AM Go to last post
  14. rebuilding engine a few questions.

    I have a 98 camaro. I removed the uim lim and both of the heads. I have mildly ported heads with springs. I want to get a mild cam nothing to...

    • Replies: 7
    • Views: 2,146
    05-30-2014 11:22 PM Go to last post
  15. Water in oil

    So my engine was just rebuilt I have all new gaskets and I checked the oil today and there's water in it. Is therei something I'm missing as far...

    • Replies: 4
    • Views: 1,500
    05-28-2014 01:06 PM Go to last post
  16. Question 3800 F-Body compatible Aluminum Oil Pan?

    Anyone aware of anything better than the stock 3800 painted metal oil pan for my 2002 Camaro 3.8L like an aluminum one? Damn thing is rusting just...

    libertyforall1776
    2 Pages
    1 2
    • Replies: 19
    • Views: 6,613
    05-25-2014 10:04 PM Go to last post
  17. Belt tensioner question

    Does anybody know where to get the clips that attach the hoses to the tensioner mine are broke and not it's leaking. Thanks

    • Replies: 5
    • Views: 1,794
    05-24-2014 10:28 PM Go to last post
  18. Stalling

    Wondering if anyone has any ideas why my car wants to stall at times when I go to stop, as if the rpm's fall to low. It also has a somewhat of a hard...

    • Replies: 0
    • Views: 1,030
    05-23-2014 06:27 PM Go to last post
  19. block plug question

    where is the block plug located on the 3.8? just got my freshly rebuilt engine in and fired it up and everything is fine except its leaking water...

    • Replies: 3
    • Views: 1,440
    05-19-2014 08:44 PM Go to last post
  20. ignition help!

    Okay guys, I have a 5 speed 1999 3800 Camaro and it has had this "false missfire" but it doesn't actually miss. I just get a SES light flashing at...

    • Replies: 0
    • Views: 991
    05-16-2014 09:01 AM Go to last post

Page 8 of 185 FirstFirst 12345678910111213141516171858108 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •