Page 7 of 185 FirstFirst 123456789101112131415161757107 ... LastLast
Threads 121 to 140 of 3685

Forum: L36 & L26 Engine Tech

Series II & Series III Factory NA 3.8L Motors


  1.   Sticky Threads  

  2. Sticky Thread Sticky: 3800 Series II Cam List

    This list covers every camshaft available for the GM 3800 Series II Engine. They are listed in increasing size starting with the STOCK cam. All...

    13secv6
    3 Pages
    1 2 3
    • Replies: 33
    • Views: 113,984
    06-29-2021 03:38 AM Go to last post
  3. Sticky Thread Sticky: L36/L26 FAQ's

    This has been a much delayed project that I unfortunately haven't had the time to focus on. Moving forward I will keep this thread open for everyone...

    • Replies: 10
    • Views: 16,529
    01-11-2015 10:18 PM Go to last post
  4. Sticky Thread Sticky: Spreadsheet for cam related info

    http://users3.ev1.net/~black_ops/cams/VE%20calculator.xls Sheet 1 - compare two cams (forum post) this was an attempt to put _ in there to keep...

    Dom
    • Replies: 3
    • Views: 15,122
    09-11-2009 07:07 AM Go to last post
  5. Sticky Thread Sticky: got a misfire? read all about it here!

    THE SYMPTOMS: poor idle, part throttle stumble, full throttle stumble, popping noises, solid illumniated "service engine soon" light, flashing...

    • Replies: 2
    • Views: 27,373
    08-16-2007 08:33 PM Go to last post
  6. Sticky Thread Sticky: FAQ: Camshafts and your car

    I have noticed a few more cam related questions popping up on the forums and figured i would throw this up here as a bit of information before you...

    • Replies: 3
    • Views: 19,212
    06-27-2006 12:11 PM Go to last post
  7. Sticky Thread Sticky: What can you expect from adding a Cam? LOOK HERE

    I have continued the assistance to everyone by gathering a list of the board members who have installed aftermarket cams. Supporting mods are...

    • Replies: 1
    • Views: 26,242
    11-17-2005 12:07 AM Go to last post
  8.   Normal Threads  

  1. 3.8 V6 Engine Built for sale

    Hi all, This is my first post here and I am extremely new to forums and whatnot. I've had my 96 Camaro for quite sometime and I blew the engine...

    • Replies: 1
    • Views: 1,645
    02-07-2015 04:30 PM Go to last post
  2. Red face Looking for any good V6 3.8L performance tips

    Hi, just bought a 2002 Camaro V6/5-speed manual from it's original owner, with less than 15,000 miles on the odometer (yes, it's true, and I have the...

    SpringerV6Camaro
    4 Pages
    1 2 3 ... 4
    • Replies: 52
    • Views: 25,049
    02-02-2015 04:47 PM Go to last post
  3. 98 3.8l camaro RANDOM MISFIRE

    first off the car seems to run pretty good, then if i rev it and hold it between 3-4k rpms the SES light will flash and it throws a random misfire...

    • Replies: 4
    • Views: 1,512
    01-17-2015 10:15 AM Go to last post
  4. Vacuum hose by radiators?

    I did a recent head gasket change and i have not been able to keep the car running. It turns on runs for about 30seconds then dies. Im assuming vac...

    • Replies: 1
    • Views: 1,248
    01-13-2015 02:01 AM Go to last post
  5. Exclamation Hesitation/stumbling Takes a while to return to idle after pushing clutch in

    Ever since having the engine completely rebuilt in November and being put back in in the beginning of December my car's been having issues. Those...

    • Replies: 0
    • Views: 1,092
    01-09-2015 05:25 PM Go to last post
  6. Cool Estimated Power

    Back in August while I was on a road rally throughout Iowa I happened to spin a bearing and got towed back to my house and that's where my project...

    • Replies: 2
    • Views: 1,354
    01-09-2015 03:19 AM Go to last post
  7. Oil hemorrhaging - what is this?

    Drove today, saw smoke behind the car, turned around, found a huge oil leak at the front of the engine. See attached photo. What is (or was, as the...

    • Replies: 3
    • Views: 1,354
    01-08-2015 10:25 AM Go to last post
  8. Lack of power / Hesitation

    Sometimes it seems like a small miss and takes longer to shift. Deff noticable on bridges (or likely hill for those of you not living on flat earth),...

    • Replies: 5
    • Views: 1,797
    01-08-2015 09:43 AM Go to last post
  9. Coolant pools on lower intake

    I started my motor after a long sit. It is white smoking badly and idle is rough. I expect some roughness; the balance shaft is inactive. I...

    • Replies: 11
    • Views: 2,785
    01-07-2015 10:36 PM Go to last post
  10. Sooo frustrated!!!!

    so I'm at my whits end with this problem. A few summers back my 2001 camaro Rs slp started to overheat and I found water in the oil so typical head...

    • Replies: 4
    • Views: 1,893
    01-03-2015 06:14 PM Go to last post
  11. Nova Project

    Sorry everyone, this is my first post on this site and I hope this is in the right place. I'm working on a 63 nova and I'm in the process of putting...

    • Replies: 1
    • Views: 1,038
    12-25-2014 06:17 PM Go to last post
  12. 3800 v6 with individual throttle bodies?

    individual throttle bodies(itb) http://www.ls1tech.com/forums/fuelin...-ls1-itbs.html Poor man's LS1 ITB fab-up - LS1TECH is for a ls1 v8 but is...

    brad99
    7 Pages
    1 2 3 ... 7
    • Replies: 94
    • Views: 39,025
    12-10-2014 03:47 PM Go to last post
  13. rev limit q's

    what is the factory rev limit on my '01 impala 3800 series II v-6 engine? this motor is no longer in a car but rather a sand rail. the only changes...

    dsrace
    2 Pages
    1 2
    • Replies: 20
    • Views: 3,906
    12-07-2014 11:19 PM Go to last post
  14. 3.8 camaro missfire

    If this has has already been. Covered I am sorry I did not see anything in the search option. I have a 3.8 v6 camaro that is missing like crazy...

    • Replies: 2
    • Views: 1,291
    11-28-2014 01:05 AM Go to last post
  15. Head gaskets don't just pop, right?

    I certainly have oil and water milkshake. I am going to do a leakdown test, but even if that comes up with one or more cylinders not holding, it...

    • Replies: 14
    • Views: 3,094
    11-28-2014 12:56 AM Go to last post
  16. engine surges after letting off the gas pedal

    so my 97 camaro started surging after letting off the gas pedal after I replaced the upper and lower intake gaskets. I think I might have damaged the...

    • Replies: 0
    • Views: 1,170
    11-09-2014 11:00 AM Go to last post
  17. Thumbs down What went bang in my enigne?

    Car is a 2001 5-speed Firebird. Build has about 100 miles on it, pretty much the works - Started with a Series 3 block from a FWD with about 18k on...

    • Replies: 2
    • Views: 1,388
    10-05-2014 10:28 PM Go to last post
  18. GT1 cam compatible with a turbo?

    Speaking in general, would a ZZP GT1 cam be an alright cam in a turbo 3800 Firebird? I looked at the specs, and I'm looking for a mild cam, looks...

    • Replies: 2
    • Views: 1,427
    09-29-2014 10:53 AM Go to last post
  19. Brian's Build

    The work bench: Pics when I first got it home from Michigan:

    shizzle24
    23 Pages
    1 2 3 ... 23
    • Replies: 334
    • Views: 57,320
    09-13-2014 08:17 AM Go to last post
  20. Holy rattle! What is it?

    Ok so I bought an 01 camaro with a 3800 and T5 with the understanding that the head gasket was blown. I checked the coolant and oil and they were...

    • Replies: 9
    • Views: 1,976
    09-06-2014 07:13 AM Go to last post

Page 7 of 185 FirstFirst 123456789101112131415161757107 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •