Page 51 of 184 FirstFirst ... 414243444546474849505152535455565758596061101151 ... LastLast
Threads 1001 to 1020 of 3679

Forum: L36 & L26 Engine Tech

Series II & Series III Factory NA 3.8L Motors


  1.   Sticky Threads  

  2. Sticky Thread Sticky: L36/L26 FAQ's

    This has been a much delayed project that I unfortunately haven't had the time to focus on. Moving forward I will keep this thread open for everyone...

    • Replies: 10
    • Views: 11,035
    01-11-2015 10:18 PM Go to last post
  3. Sticky Thread Sticky: 3800 Series II Cam List

    This list covers every camshaft available for the GM 3800 Series II Engine. They are listed in increasing size starting with the STOCK cam. All...

    13secv6
    3 Pages
    1 2 3
    • Replies: 32
    • Views: 76,397
    05-03-2012 06:06 PM Go to last post
  4. Sticky Thread Sticky: Spreadsheet for cam related info

    http://users3.ev1.net/~black_ops/cams/VE%20calculator.xls Sheet 1 - compare two cams (forum post) this was an attempt to put _ in there to keep...

    Dom
    • Replies: 3
    • Views: 11,202
    09-11-2009 07:07 AM Go to last post
  5. Sticky Thread Sticky: got a misfire? read all about it here!

    THE SYMPTOMS: poor idle, part throttle stumble, full throttle stumble, popping noises, solid illumniated "service engine soon" light, flashing...

    • Replies: 2
    • Views: 22,811
    08-16-2007 08:33 PM Go to last post
  6. Sticky Thread Sticky: FAQ: Camshafts and your car

    I have noticed a few more cam related questions popping up on the forums and figured i would throw this up here as a bit of information before you...

    • Replies: 3
    • Views: 15,169
    06-27-2006 12:11 PM Go to last post
  7. Sticky Thread Sticky: What can you expect from adding a Cam? LOOK HERE

    I have continued the assistance to everyone by gathering a list of the board members who have installed aftermarket cams. Supporting mods are...

    • Replies: 1
    • Views: 22,143
    11-17-2005 12:07 AM Go to last post
  8.   Normal Threads  

  1. Gasket inquiry

    Ok so I had a coolant leak - it was leaking from behind the intake manifold, and into the crank case.... So I replaced the intake gaskets (used the...

    • Replies: 2
    • Views: 609
    06-27-2010 07:25 PM Go to last post
  2. coolent leak

    ok i notice i have a coolent leak, it seems to be mostly on passenger side and down the front of the engine right under the intake. is this intake...

    • Replies: 10
    • Views: 1,189
    06-27-2010 07:59 AM Go to last post
  3. Newbie question

    Will an 98-02 LS1 starter work for or fit a 98 V6? Sorry if this is the wrong section

    • Replies: 1
    • Views: 380
    06-26-2010 02:56 PM Go to last post
  4. Car down for 2 days please help.

    I have recently been having problems starting my car, 1996 pontiac firebird 3.8, i thought that it might be the ignition switch so i changed that...

    • Replies: 5
    • Views: 697
    06-24-2010 09:28 PM Go to last post
  5. P1515 P1516 and Red Eng Power

    Anybody know wtf is going on? Reduced engine power light goes back off after a while. TPS? FPR? IAC?

    • Replies: 1
    • Views: 1,590
    06-24-2010 05:55 PM Go to last post
  6. l36 and l67 crank pulleys

    so Im swapping out my crank pulley and see that the l67 pulley might need a bigger key on the crank itslef is this correct or can I use my l36 key....

    • Replies: 1
    • Views: 867
    06-24-2010 05:43 PM Go to last post
  7. people who have l26 in their fbodys

    Can i use the fwd balancer pully from the fwd engine? or do i have to use my rwd one? They are a little different but i cant see any reason why i...

    • Replies: 3
    • Views: 659
    06-23-2010 09:37 PM Go to last post
  8. 02 sensor???? maybe???

    Ok so here is what's going on, a few days ago I was driving and a SES light came on. On the way to the part's store already I figured that I would...

    • Replies: 6
    • Views: 912
    06-22-2010 05:07 PM Go to last post
  9. Crankshaft Position sensor or Camshaft Position Sensor?

    In relation to my starting issues. It was suggested to me that my crankshaft position sensor could be bad, which would cause my injectors to not...

    skimphish
    4 Pages
    1 2 3 ... 4
    • Replies: 56
    • Views: 27,987
    06-22-2010 01:42 PM Go to last post
  10. Engine misfiring

    Last week I replaced my spark plugs with AC delco 41-101. Instantly I noticed my engine was misfiring. I took out all the spark plugs and re gapped...

    • Replies: 3
    • Views: 586
    06-22-2010 10:39 AM Go to last post
  11. Stall and gears?

    My V6 2000 Camaro is my daily driver, and I'm taking it to school 9 hours away, so putting a cam in, or FI, or full headers and exhaust isn't on my...

    • Replies: 10
    • Views: 834
    06-21-2010 11:43 PM Go to last post
  12. intake help

    Will a 1998 camaro upper and lower intake manifold work on my 1996 camaro 3.8. . I noticed they are slightly different..

    • Replies: 0
    • Views: 465
    06-21-2010 09:13 PM Go to last post
  13. pacesetter headers w/ electronic cutouts?

    Im wondering if anyone has done this. If so does it sound good and how difficult was it to do. btw its a 98 camaro w/ l36

    • Replies: 6
    • Views: 799
    06-21-2010 08:32 PM Go to last post
  14. fuel metering system

    I have my service engine light on and when I plugged in the obd machine it told me theres a problem with my fuel metering system. Can anyone tell me...

    • Replies: 6
    • Views: 577
    06-18-2010 03:25 PM Go to last post
  15. Help me decide which Block to go with

    My 98 firebird spun a bearing. It had 180k on it, so it was destined for a hearttransplant anyways. I found a 2007 L26 from a Buick Lucerne...

    • Replies: 12
    • Views: 1,076
    06-18-2010 11:47 AM Go to last post
  16. need help fast

    my camaro is stuck on stupid. anything more than extremely light throttle makes it shutter and lose power. i had the codes pulled yesterday and the...

    • Replies: 4
    • Views: 658
    06-18-2010 06:23 AM Go to last post
  17. What transmission comes on the 2007 Buick Lucerne?

    I bought an 07 Buick Lucerne 3.8 L26 engine and transmission combination. It's an automatic. Is it a 4L60E? Any idea what other cars it would fit on?

    • Replies: 5
    • Views: 679
    06-16-2010 07:35 PM Go to last post
  18. burning oil?

    okay so apart from my other problems with the car i seem to burn enormous amounts of oil....i never see any leaks on the ground but i checked it...

    • Replies: 5
    • Views: 794
    06-16-2010 07:34 PM Go to last post
  19. Where to start :(

    P0102 Mass or volume air flow circuit low input P0122 throttle/pedal postion sensor/siwtch A circuit low input P0306 Cylinder 6 misfire detected...

    • Replies: 9
    • Views: 1,151
    06-15-2010 10:51 PM Go to last post
  20. Does anybody know?

    I really need some help with this rear main seal. I have transmission out and im going to do the oil pan gasket too, so my question about the rear...

    • Replies: 5
    • Views: 979
    06-15-2010 07:45 PM Go to last post

Page 51 of 184 FirstFirst ... 414243444546474849505152535455565758596061101151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •