Page 4 of 185 FirstFirst 123456789101112131454104 ... LastLast
Threads 61 to 80 of 3685

Forum: L36 & L26 Engine Tech

Series II & Series III Factory NA 3.8L Motors


  1.   Sticky Threads  

  2. Sticky Thread Sticky: 3800 Series II Cam List

    This list covers every camshaft available for the GM 3800 Series II Engine. They are listed in increasing size starting with the STOCK cam. All...

    13secv6
    3 Pages
    1 2 3
    • Replies: 33
    • Views: 112,467
    06-29-2021 03:38 AM Go to last post
  3. Sticky Thread Sticky: L36/L26 FAQ's

    This has been a much delayed project that I unfortunately haven't had the time to focus on. Moving forward I will keep this thread open for everyone...

    • Replies: 10
    • Views: 16,222
    01-11-2015 10:18 PM Go to last post
  4. Sticky Thread Sticky: Spreadsheet for cam related info

    http://users3.ev1.net/~black_ops/cams/VE%20calculator.xls Sheet 1 - compare two cams (forum post) this was an attempt to put _ in there to keep...

    Dom
    • Replies: 3
    • Views: 14,913
    09-11-2009 07:07 AM Go to last post
  5. Sticky Thread Sticky: got a misfire? read all about it here!

    THE SYMPTOMS: poor idle, part throttle stumble, full throttle stumble, popping noises, solid illumniated "service engine soon" light, flashing...

    • Replies: 2
    • Views: 27,113
    08-16-2007 08:33 PM Go to last post
  6. Sticky Thread Sticky: FAQ: Camshafts and your car

    I have noticed a few more cam related questions popping up on the forums and figured i would throw this up here as a bit of information before you...

    • Replies: 3
    • Views: 19,011
    06-27-2006 12:11 PM Go to last post
  7. Sticky Thread Sticky: What can you expect from adding a Cam? LOOK HERE

    I have continued the assistance to everyone by gathering a list of the board members who have installed aftermarket cams. Supporting mods are...

    • Replies: 1
    • Views: 26,011
    11-17-2005 12:07 AM Go to last post
  8.   Normal Threads  

  1. Throttle body intake charge shaper?

    I've got a pre-series 1 3800 that has a honeycombed wafer that is held in the throttle body intake port by a C clip. It looks like all it does is...

    • Replies: 0
    • Views: 1,482
    03-07-2016 04:48 PM Go to last post
  2. 3.8(229) vs 3.8(231)

    Hello I am new to this forum and but know a little about the 3.8s engines.I do know a lot lsx,sbc,and bbc platforms but the 3.8s are...

    • Replies: 2
    • Views: 5,080
    02-08-2016 09:58 AM Go to last post
  3. 97 v6 3.8 camaro any suggestions

    I have a 1997 v6 3.8 series 2 Camaro I'm looking for any suggestions on how to make it faster and more fuel efficient or heck even make it look cooler

    • Replies: 0
    • Views: 1,377
    02-07-2016 11:57 PM Go to last post
  4. Coolant in oil

    So I decided to change the oil in my camaro this morning and got a distasteful surprise of coolant in the oil. Except the car hasn't lost any coolant...

    • Replies: 8
    • Views: 3,187
    02-06-2016 06:34 PM Go to last post
  5. Coil packs

    Just a quick question. I need to replace the coil packs I my 01 camaro. The gm coils are rated at 55k volts while the msd are 45k volts. Are any of...

    bachert24
    2 Pages
    1 2
    • Replies: 15
    • Views: 5,013
    02-04-2016 04:20 PM Go to last post
  6. need help

    I have a 94 camaro that had a 3.4l i swapped to a 3.8l it turns over and has spark and runs off starting fluid but fuel pump wont turn on any...

    • Replies: 1
    • Views: 1,736
    01-20-2016 12:29 PM Go to last post
  7. HEX air vents

    Hi guys,i installed a pair of HEX air vents on my camaro.my cousin has them on his 2013 1LE and i saw how fuctional they were so i decided to put...

    • Replies: 0
    • Views: 1,279
    12-29-2015 01:20 PM Go to last post
  8. Dilemma regarding power steering pump

    Hello, looking for second opinion. Vehicle is a 2000 Pontiac Firebird v6. One of the mounting bolts for the power steering pump had snapped in half....

    • Replies: 0
    • Views: 1,373
    11-14-2015 11:36 AM Go to last post
  9. 94 F body suggestions

    I have a 94 camaro 3.4, just pulled the entire drive line and dismantled the engine completely because it was locking up on me at startup. Needless...

    • Replies: 2
    • Views: 1,508
    11-03-2015 03:56 PM Go to last post
  10. 1994 camaro 3.4l to 97 camaro rs 3.8l

    I recently did a swap in my camaro from 3.4l to 3.8l. My issues are that the motor turns over, im getting spark just no fuel i noticed new hernness...

    • Replies: 0
    • Views: 1,227
    10-30-2015 09:45 PM Go to last post
  11. Timing Cover Help?

    So I've recently tried to replace my timing cover gasket while doing my oil pump, and the first time I went just dry gasket no sealant, found coolant...

    • Replies: 5
    • Views: 2,008
    10-27-2015 08:48 PM Go to last post
  12. New car and need some help.

    Ok so i just purchased a 97 chevy camaro. I need help with a head gasket issue the previous owner was having. I know a little bit about the car. The...

    • Replies: 0
    • Views: 1,187
    10-27-2015 03:46 PM Go to last post
  13. Harmonic Balancer Prayers Have Been Answered!

    I contacted a company last week to see if they make anything that would work on my car. They initially said no. Through more emails and talking to...

    • Replies: 5
    • Views: 2,456
    10-26-2015 03:49 PM Go to last post
  14. flywheel

    Is there some special way to get the last bolt in on the flywheel on the camaros? It doesn't matter which bolt is last either and they all go in...

    • Replies: 1
    • Views: 1,303
    10-25-2015 07:37 PM Go to last post
  15. Engine Noise

    Greetings, here is the question. I recently installed GM Supercharged 3.8L V-6 in a 1985 Chevy Celebrity Euro Sport 2 door coupe. I was told that the...

    • Replies: 1
    • Views: 1,292
    10-25-2015 09:45 AM Go to last post
  16. Engine noise

    Greetings, here is the question. I recently installed GM Supercharged 3.8L V-6 in a 1985 Chevy Celebrity Euro Sport 2 door coupe. I was told that the...

    • Replies: 0
    • Views: 989
    10-25-2015 09:30 AM Go to last post
  17. 3.73 gears

    Anybody know of good 3.73 gears for 97 camaro 3.8l.

    • Replies: 2
    • Views: 1,941
    10-23-2015 06:51 PM Go to last post
  18. 3.8L misfire. need help

    I have a 1996 pontiac firebird with the 3.8L v6 and I have a misfire on cylinder #1 and cant figure it out. I replaced the spark plugs with ngk...

    • Replies: 4
    • Views: 2,017
    10-23-2015 06:50 PM Go to last post
  19. Oil Pan Removal?

    (2002 Camaro V6 3.8) So for the past month now I've been struggling to completely remove my oil pan to access my bearings, but I've now ran into a...

    • Replies: 3
    • Views: 1,839
    10-23-2015 06:36 PM Go to last post
  20. exhaust opinions

    I currently have obx shorty headers on my camaro 3.8 with y pipe and borla cat back off my buddys lt1 camaro. im gonna go with borla xr1 mufflers...

    camaro211z28
    2 Pages
    1 2
    • Replies: 25
    • Views: 6,547
    10-23-2015 06:34 PM Go to last post

Page 4 of 185 FirstFirst 123456789101112131454104 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •