Page 10 of 185 FirstFirst 123456789101112131415161718192060110 ... LastLast
Threads 181 to 200 of 3685

Forum: L36 & L26 Engine Tech

Series II & Series III Factory NA 3.8L Motors


  1.   Sticky Threads  

  2. Sticky Thread Sticky: 3800 Series II Cam List

    This list covers every camshaft available for the GM 3800 Series II Engine. They are listed in increasing size starting with the STOCK cam. All...

    13secv6
    3 Pages
    1 2 3
    • Replies: 33
    • Views: 112,285
    06-29-2021 03:38 AM Go to last post
  3. Sticky Thread Sticky: L36/L26 FAQ's

    This has been a much delayed project that I unfortunately haven't had the time to focus on. Moving forward I will keep this thread open for everyone...

    • Replies: 10
    • Views: 16,176
    01-11-2015 10:18 PM Go to last post
  4. Sticky Thread Sticky: Spreadsheet for cam related info

    http://users3.ev1.net/~black_ops/cams/VE%20calculator.xls Sheet 1 - compare two cams (forum post) this was an attempt to put _ in there to keep...

    Dom
    • Replies: 3
    • Views: 14,885
    09-11-2009 07:07 AM Go to last post
  5. Sticky Thread Sticky: got a misfire? read all about it here!

    THE SYMPTOMS: poor idle, part throttle stumble, full throttle stumble, popping noises, solid illumniated "service engine soon" light, flashing...

    • Replies: 2
    • Views: 27,071
    08-16-2007 08:33 PM Go to last post
  6. Sticky Thread Sticky: FAQ: Camshafts and your car

    I have noticed a few more cam related questions popping up on the forums and figured i would throw this up here as a bit of information before you...

    • Replies: 3
    • Views: 18,979
    06-27-2006 12:11 PM Go to last post
  7. Sticky Thread Sticky: What can you expect from adding a Cam? LOOK HERE

    I have continued the assistance to everyone by gathering a list of the board members who have installed aftermarket cams. Supporting mods are...

    • Replies: 1
    • Views: 25,985
    11-17-2005 12:07 AM Go to last post
  8.   Normal Threads  

  1. 2 step - launch control

    i'm looking for some boost off the line. is anybody out there using a 2 step? there are so many boxes out there. and i don't know whats compatible...

    thebeewantsboost
    2 Pages
    1 2
    • Replies: 16
    • Views: 7,413
    01-28-2014 06:50 PM Go to last post
  2. 3800 non sc swap for 3800 sc

    Hey guys new to the forum the motor in my car spun a bearing siezed up its done not even gonna try saving it I already know it's junk. I want to take...

    • Replies: 3
    • Views: 1,605
    01-20-2014 10:33 AM Go to last post
  3. Oops...

    Well I was removing the heater core hoses from the firewall and I noticed this T with one thing hose going to the cab and other to the intake...now...

    • Replies: 2
    • Views: 1,364
    01-18-2014 08:13 PM Go to last post
  4. Help!

    1998 Pontiac Firebird 3.8, got the car like 2 months ago, when I first got it, I noticed that it would take a while for it to turn on, I had to leave...

    • Replies: 3
    • Views: 1,315
    01-09-2014 11:46 AM Go to last post
  5. No Power at WOT

    More exactly, no power at WOT and any throttle input that pushes the car above ~3k rpm before shifting. It has very limited acceleration and revs...

    • Replies: 9
    • Views: 1,741
    12-26-2013 10:53 PM Go to last post
  6. what is the normal oil pressure for 02 firebird v6?

    Hi all, might be having oil pump probs, I was wondering the normal oil pressure for my 02 firebird v6. Thanks

    • Replies: 6
    • Views: 2,461
    12-23-2013 01:44 PM Go to last post
  7. ignition problem...

    Yesterday i was at the gym and when i went to turn my car off, my key turned back and i pulled it out and the car was still running. i put the key...

    • Replies: 2
    • Views: 1,350
    12-01-2013 08:25 PM Go to last post
  8. Completed the head gasket set install now white smoke after starting...<Video>

    I completed the head gasket/intake manifold gaskets on my 96 Camaro. Well I started it up for the first time and was expecting a rough start and for...

    Pure_Camaro
    2 Pages
    1 2
    • Replies: 16
    • Views: 3,872
    11-26-2013 01:04 PM Go to last post
  9. questions after installing headers

    Before I start asking I want to make it known that I am not a mechanical genius so I appologize ahead of time if any of my questions sound ignorant. ...

    • Replies: 5
    • Views: 1,625
    11-21-2013 02:56 PM Go to last post
  10. starter noise after flywheel replacement

    over the weekend I replaced my entire clutch system, clutch, pressure plate, flywheel and slave and master cylinder... when I start my car and its...

    • Replies: 0
    • Views: 927
    11-13-2013 09:35 AM Go to last post
  11. Need help 3.8 bird

    car jerks only when put into reverse and oil gauge spikes when it jerks any ideas what can this be ? car was sitting for a few months I'm change all...

    • Replies: 0
    • Views: 1,294
    11-13-2013 05:43 AM Go to last post
  12. Found a good double roller timing chain

    This has been something I've been working on recently. I have an older JP double roller timing set, the one that supposedly had no problems. The...

    MusicMan
    3 Pages
    1 2 3
    • Replies: 39
    • Views: 12,546
    11-12-2013 06:18 PM Go to last post
  13. Electrical - low voltage > 1150 rpm & p0151 code

    I have a new weird electrical issue. It all began as soon as I got my car back from a shop that changed my head gaskets. When I start my car my...

    • Replies: 1
    • Views: 1,375
    11-11-2013 09:19 PM Go to last post
  14. Tapping noise and loss of power.

    So a few months ago my brother was driving my 96 Camaro RS home from work. When he got home he told me that there was some kind of noise coming from...

    Pure_Camaro
    2 Pages
    1 2
    • Replies: 27
    • Views: 4,917
    11-11-2013 06:05 AM Go to last post
  15. Introduction & L26 to F-body questions

    Hey guys. I'm new here. Thank you for having me on. I'm Manuel but everyone calls me PB. I own a 95 and 98 firebird. I painted my 98 flat black its...

    • Replies: 4
    • Views: 1,778
    11-07-2013 07:28 PM Go to last post
  16. clutch opinions

    Never had my trans out of the car myself. I have had the car for 2-3 years and it drives great no clutch slipping issues at all BUT I do not know...

    • Replies: 5
    • Views: 1,610
    11-07-2013 12:01 PM Go to last post
  17. pollution control elimination questions?

    Before I put an L26 in my firebird I'd like to eliminate as much of the pollution control mess in my car but still make sure it runs well. I live in...

    • Replies: 5
    • Views: 1,520
    11-07-2013 09:06 AM Go to last post
  18. Auto to manual swap?

    I would like to change out my auto trans for a manual 5 speed on my 98 3.8 firebird. Anyone have any advice on this topic? I have a guy that will...

    • Replies: 1
    • Views: 1,141
    11-06-2013 02:55 AM Go to last post
  19. Sensor Fuse Blowing

    I know there have been other posts on this subject but none have really helped me. I have a 1999 Camaro V6 and several months ago I had the sensor...

    • Replies: 0
    • Views: 932
    11-05-2013 07:31 PM Go to last post
  20. Rough Idle when cold.

    Hey guys, car has been idling rough on cold starts. It stutters and doesn't have power for about 20-30 seconds then it's perfectly fine. No loss of...

    • Replies: 1
    • Views: 1,150
    11-04-2013 12:27 PM Go to last post

Page 10 of 185 FirstFirst 123456789101112131415161718192060110 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •