Page 1 of 184 123456789101151101 ... LastLast
Threads 1 to 20 of 3672

Forum: L36 & L26 Engine Tech

Series II & Series III Factory NA 3.8L Motors

  1.   Sticky Threads  

  2. Sticky Thread Sticky: L36/L26 FAQ's

    This has been a much delayed project that I unfortunately haven't had the time to focus on. Moving forward I will keep this thread open for everyone...

    • Replies: 10
    • Views: 10,135
    01-11-2015 10:18 PM Go to last post
  3. Sticky Thread Sticky: 3800 Series II Cam List

    This list covers every camshaft available for the GM 3800 Series II Engine. They are listed in increasing size starting with the STOCK cam. All...

    3 Pages
    1 2 3
    • Replies: 32
    • Views: 66,138
    05-03-2012 06:06 PM Go to last post
  4. Sticky Thread Sticky: Spreadsheet for cam related info Sheet 1 - compare two cams (forum post) this was an attempt to put _ in there to keep...

    • Replies: 3
    • Views: 10,834
    09-11-2009 07:07 AM Go to last post
  5. Sticky Thread Sticky: got a misfire? read all about it here!

    THE SYMPTOMS: poor idle, part throttle stumble, full throttle stumble, popping noises, solid illumniated "service engine soon" light, flashing...

    • Replies: 2
    • Views: 21,594
    08-16-2007 08:33 PM Go to last post
  6. Sticky Thread Sticky: FAQ: Camshafts and your car

    I have noticed a few more cam related questions popping up on the forums and figured i would throw this up here as a bit of information before you...

    • Replies: 3
    • Views: 14,553
    06-27-2006 12:11 PM Go to last post
  7. Sticky Thread Sticky: What can you expect from adding a Cam? LOOK HERE

    I have continued the assistance to everyone by gathering a list of the board members who have installed aftermarket cams. Supporting mods are...

    • Replies: 1
    • Views: 21,450
    11-17-2005 12:07 AM Go to last post
  8.   Normal Threads  

  1. Abbot racing cam

    Just looking for some input from anyone who has used the ARH n/a cam. This car will probably never see the track, so I really don't care about top...

    • Replies: 3
    • Views: 359
    11-23-2018 04:11 PM Go to last post
  2. P0327 knock sensor 1 circuit low input HELP!!

    Hey guys. About two weeks ago both my knock sensors went. Got them both replaced with new pigtails and now the passenger side is fine but the driver...

    • Replies: 3
    • Views: 153
    11-13-2018 08:46 PM Go to last post
  3. Oil Filter Cross Reference for our 3800's? and cheapest place to buy more filters?

    My first question is what other filters fit on our cars? I searched a few times on this forum to find nothing. I'm curious if there are larger...

    2 Pages
    1 2
    • Replies: 19
    • Views: 10,153
    11-05-2018 01:05 PM Go to last post
  4. Question TTY bolts discontinued.... now what?

    Hi All, new member here. I have a 2002 firebird with the L36 engine. Has rod knock so decided to purchase a used motor. Got it, disassembled and...

    • Replies: 3
    • Views: 227
    11-01-2018 06:04 AM Go to last post
  5. Smile KOkro sk ik dsiew kdsd

    COWBOYS VS TEXANS Live Streaming Dallas Cowboys vs Houston Texans Live Streaming Cowboys vs Texans Live Streaming

    • Replies: 1
    • Views: 184
    10-11-2018 10:05 PM Go to last post
  6. Exclamation TE jfd isfkdf ikdfld kfkdfdf

    Titans vs Bills Live Streaming Dolphins vs Bengals Live Streaming Panthers vs Giants Live Streaming Ravens vs Browns Live Streaming

    • Replies: 0
    • Views: 136
    10-07-2018 10:33 AM Go to last post
  7. Wink Gdj jwe jfdsio wklds ds

    dfsafdsfd/sgds dsg/ds/gds g/dsg/ds gd/sg/dsg ds/g/dsg we/ds/gd sgd/sg/ds/dsdsfd

    • Replies: 0
    • Views: 131
    10-07-2018 10:31 AM Go to last post
  8. Cam timing?

    Has anyone adjusted the cam timing with a stock cam? I bought a rollermaster timing chain and I'm wondering if it would be better to advance the cam...

    • Replies: 7
    • Views: 294
    09-23-2018 11:24 AM Go to last post
  9. high compression pistons

    anyone know where i could get 11:1 pistons for my 3800 from ? without having to sell a kidney first ?... im not going to be running any nitrous, just...

    • Replies: 5
    • Views: 497
    07-30-2018 01:04 PM Go to last post
  10. Need help boosting my car

    Hello I am trying to boost my 2002 firebird 3.8 5 speed. Now I found a kit on ebay can some one tell me what else I will need. Thanks for the help.

    • Replies: 8
    • Views: 378
    07-26-2018 01:40 PM Go to last post
  11. Need help boosting my car

    Hello I am trying to boost my 2002 firebird 3.8 5 speed. Now I found a kit on ebay can some one tell me what else I will need. Thanks for the help.

    • Replies: 0
    • Views: 162
    07-25-2018 10:11 AM Go to last post
  12. mileage too high for a new cam

    so my 2000 camaro 3.8l has about 162000 miles on it. im the original owner, and have religiously changed the oil and filter every 3600 miles since i...

    • Replies: 9
    • Views: 735
    06-19-2018 10:57 AM Go to last post
  13. 3800 Datsun 210

    Hey Guys! I plan to start my Datsun swap here soon and wanted to ask a few questions. Any help is appreciated! I Plan to use the entire drive train...

    • Replies: 1
    • Views: 950
    12-05-2017 07:26 AM Go to last post
  14. Fuel system upgrades

    Over the weekend, right before I left for a race of course, my Camaro decided it no longer wanted to start. It started up perfectly fine just an hour...

    • Replies: 1
    • Views: 738
    09-01-2017 03:53 AM Go to last post
  15. car runs like crap

    Hey guys, I have a 00 camaro 3.8 that i just did a turbo set up for. The car has a intense stage 2 cam, matching springs, slightly ported heads, no...

    • Replies: 3
    • Views: 1,309
    05-13-2017 06:07 PM Go to last post
  16. 3800 Series II NA. Head Milling

    Ok, so I've seen a lot of numbers thrown around, but I can't find the right number. Does anybody know what the Max i can take off of these heads is...

    • Replies: 6
    • Views: 1,645
    04-11-2017 12:28 PM Go to last post
  17. camaro 3.8 turbo

    just wondering if anyone on here has done a 3.8 turbo in a 2000 camaro? I just did this and the car is running really crappy. I used slightly ported...

    • Replies: 2
    • Views: 1,322
    04-07-2017 09:53 AM Go to last post
  18. 1999 Camaro dies at idle and when given throttle

    As the title states, the engine isn't even really running right now. It's not my car, but it's in the family. I have yet to hook up a fuel pressure...

    • Replies: 1
    • Views: 589
    02-18-2017 02:43 PM Go to last post
  19. Unhappy Bolt List????

    anybody know of a list floating around that may have all the bolts and their sizes listed? I've had my engine (L36) in pieces for the last 8...

    • Replies: 4
    • Views: 979
    01-05-2017 11:14 AM Go to last post
  20. random question ... L67 pistons on L36 rods...

    okay after looking around I know the l36 is a longer rod then the l67. Partially to do with the wrist pin location on the pistons between the two. ...

    • Replies: 1
    • Views: 675
    12-31-2016 07:43 PM Go to last post

Page 1 of 184 123456789101151101 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts