Forum: 60º V6 Engine Tech

Hey guys, I've got a 98 trans am shell that I picked up and swapped my 1995 3.4L/3400 Top End swapped engine into. I've got it started and running...

Has anyone heard of or tried, running a 60 degree on a Buick 3.8 sfi ecm? One part # I know of is a 16141470.

So my 95 3.4l v6 camaro started having issues starting. It started with hard starts but once it was on everything was fine. Then eventually it would...

Anybody know what this does? Sure it’s advertised as a camshaft seal, but is it used in the 2.8/3.4/3400/3500? Anybody using them?

just curious as to if the oil can leak on the side of a 3100 head gasket? this is the side to the right front head I mean we are talking small...

Hey how r u. Please help I would like to turbo my 3800 v6. Something like the 20 Anniversary Transam. Would like Hp between 350 to 400. Thank you...

Hi everyone...first post here, I have a '95 3.4L Camaro. I've been trying to fix it up a bit to drive it occasionally, and it has 172K on it now....

Would this be a good swap in my 95 3.4 camaro. what kind of performance, gas mileage increase could i get from this? tell me what you think?

I have a 95 3.4l Camaro. It's got 220k on the body but the engine is a pull out from another 95 with around 80k on it and has been in the car for a...

Hi I can't find a place to buy a 24X crank sensor. ( GM part # 10137663 ) dealer is discontinued / I can't find aftermarket PLEASE HELP!!!! ...

Need help. What are you all running? I have stamped Steel Comp roller tip 1.6 rockers. Will Poly locks fit under the stock valve covers? I...

Okay, I realize I'm like 10 years late to the non hybrid 60 Degree V6 performance stuff ... and theres a TON of excellent info out there, but I...

I'm working on a project car and am thinking about using a 3.4 out of Firebird/Camaro as the donor engine. For ease of tuning, I'd like to use a set...

Hey everyone! I'm a long time lurker on almost every v6-fbody site and I'm looking for some help with a new build. I've read a lot of threads about...

I was wondering if somebody could plug my #'s into desktop dyno or similar and give a rough estimate power #. Or even better if someone has the same...

I am in the process of rebuilding my chevy venture motor. Could not find any good 3.4 blocks. Came up with a 3.1 good block from a 97 Lumina. My van...

I just recently moved out of California where the smog is only a tailpipe sensor and a couple of revs (without even getting out of the car). I was...

Has anyone actually finished a 3.4/3x00 hybrid engine and driven it? I'm finding tons of threads where people have started a build but then I never...