Forum: F-Body Drivetrain

As title says. I can move the shifter right towards the 5th/reverse side, but if i try to go forward/back, it does not move. I already replaced the...

cant get the stupid clutch line at the slave to release...tried the 2 screwdriver method and nothing..any suggestions?

So I cant find a strait answer on this... so a postin I am... I have a 1996 camaro 3.8 that I converted to a 5-speed and immediately destroyed the 2...

My tranny is shot in my Camaro. Gave a good run with 231 on the clock . Is there any real difference (im a noob when it comes to trannys) with a...

So just like it says its a 99 v6 with a 5 speed that will not disengage. Only 80k miles. I put a spec stage 3+ in this thing about 2 years ago and...

Ok i have a real simple question. I have my motor and tranny out and i went underneath the car and the bushing/ bearing is very loose and theres not...

So I had a auto in my camaro that slipped so I put a 5-speed in it. I was pulling onto a hwy. ripped threw first, power shifted into 2nt and just...

How can I check the front seal on my 4l60e transmission? Its out of the car now, like can I stand it up on the bellhousing? thanks

At what hosepower does a stock clutch start to slip on a 99 v6 camaro?

before i take it to the mechanic im sure everyone on here has good insight and could maybe help me out. my tranny keeps acting up whenever i shift...

Before I get into this let me state for the record that I have searched high and low already and not gotten a clear answer on this subject. I...

Is it necessary to go with a built transmission if you plan on going FI? What kind of limits are there for the stock transmission and stage I, II,...

anyone have part numbers for both gaskets?

I currently have a 2 peice drive shaft in my car and center support baring is starting to have some play in it. So instead of replacing it I found a...

Ok Guys, I need some help here. Auto Trans, 99 Firebird 3.8 Drove home through a big puddle, and now my shifter is out of wack. Can't find...

Well the other day i get my car back from getting the transmission rebuilt and the shop tells me that it seems that the axle bearing on the passenger...

Ok my trans is acting a tad better now but it still has a problem when it is driven for a long time. Essentially after about 60 miles or 35-45...

Well Got a buddies 99 v6 camaro and it seems like the slave cyl. is shot. Well I did a clutch on this thing about 3 years ago and it was a total pain...

got my hurst billet shifter on and it feels like its not goin into 2nd and dosent wanna go into 4th should i adjust my shifter or what is it?