View Full Version : v6 - v8 swap
onenice3.4
12-24-2006, 08:12 AM
is it possible to do the swap without to much fabrication? i dont wanna replace the rear end, the radiator or any of that. is this possible or should i just keep the v6 in it?
also how hard is it to do a auto - 5spd tranny swap?
FunkZ
12-24-2006, 10:32 AM
www.v6conversion.com
Adrenaline
12-24-2006, 11:03 AM
Buy a v8 car youll be spending more on the parts for the conversion than buying a car with an Ls1 in it.
Silversixspeed
12-24-2006, 11:30 AM
Buy a v8 car youll be spending more on the parts for the conversion than buying a car with an Ls1 in it.
i agree with that.. i went through the same dilemma
dont do it unless you are looking for a project.. and a project that's gonna hurt you a little financially.. its possible, but you are soooo much better off just buying a car with a v8 already in it.
06camarodude
12-24-2006, 03:46 PM
Or you could always buy a totaled V8 car and swap the whole K-member with the motor and trans, and you'll also have the ds and the rear end to swap. . . All you would need besides that is the wiring harness. . .
Powered by vBulletin™ Version 4.0.5 Copyright © 2010 vBulletin Solutions, Inc. All rights reserved.